|
SAC-H
especially for spaces limited in height and
width (ideal for trucks and vans), it can be mounted
between main frame member and outer skirt of
the vehicle, or mounted on exterior wall of the van. A
variety of supply and return air openings are
available to fit
the individual application.
SAC-C
Designed for use where overall space is limited.
Top or front discharge allows flexible installation
to meet space restrictions.
SAC-FS
Designed to fit a variety of requirements from small
to largest areas . Alternate discharge openings
provide maximum locationing, FS model can be installed
outside the van, etc., with use of flexible hose,
or as an interior-mounted
model. Some units are available in single or
two stage configurations.
|
1-Weigth-
Approximate weight of standard units, lbs.
2.
Air quantity- At sea level and static
pressure external of unit at 5”
water cage CFM
3.
Cooling capacity – at ambient
conditions indicated, tons of refrigeration (one
ton of refrigeration
is equal to 12,000
BTU per hour
cooling capacity) cooling capacity
based on air entering unit at 80ºF. dry bulb
and 67º wet bulb
with air
quantity indicated
in chart.
4.
Power Required – Most units are
available in
208, 220, 230, 440 volt, single or three
phase, 60 cycle power 50 Hz, also available.
|
High
temperature
SAC units are available for special
order
wich will deliver rated capacity @
125ºF. Standard SAC units
will operate
satisfactory in ambients up to
115ºF. but at reduced capacities
|
1.
Condenser
air discharge (protected by safety screen)
2.
Return air openings. *
3.
Supply air openings *
*single
cooling stage unit normally has only one
return opening.
|
